Maxxon Isolate Two-Part, Water-Based Epoxy 4 Gallon Kit

Maxxon Isolate 13012

Maxxon Commercial Isolate is a two-part, water-based epoxy that prevents the migration of moisture vapor and abatement chemicals from the concrete slab.

Isolate Features

• 4-gallon pail
• Two-part, water-based epoxy
• Designed to create an isolating barrier to protect flooring systems from asbestos and chemically abated slabs
• Capped with a Maxxon underlayment system, Maxxon Commercial Isolate provides a permanent barrier protecting the flooring
• It can also be used over chemically-abated concrete, old adhesives cutback, asphalt-based products, old, non-water-soluble adhesives, well-secured VAT, VCT, or ceramic tiles, and other solid surfaces
• Isolates asbestos, chemically-abated slabs, and surface alkalinity up to a pH of 14
• It provides a moisture vapor barrier
• MVER Limits: 14 lbs. MVER with one coat and 19 lbs. MVER with two coats
• Ideal for use on well-bonded VAT, VCT, and ceramic tile
• For use on slabs contaminated by polychlorinated biphenyls (PCBs)
• Can be capped in as little as 6 hours after installation
• Roller-applied for easy application
• Up to 100% RH
• Pot Life at 73 °F (22.8 °C) is 40 min.
• 4-6 hour dry time (with full trade traffic after 24 hours)
• Coverage: 150 ft2/gal (3.7 m2/l; 600 ft2 (55.7 m2)/kit

Where to use

• Above-, below- and on-grade concrete-based construction applications
• Interior on-grade and below-grade concrete slabs
• Existing floor coverings

Limitations

• For interior use only
• Do not allow the product to freeze
• Do not store below 40 °F (4.4 °C)
• Do not use if ambient or concrete surface temperatures are below 40 °F (4.4 °C) or above 90 °F (32 °C)
• Do not dilute the product
• If desired, construct a mock-up to verify compatibility with the finished flooring
• Do not use it as a worn surface. Contact Maxxon Corporation for more information
• Do not clean the concrete substrate/subfloor with oil-based or silicone-based sweeping compounds. These compounds leave a film on the subfloor surface, interfering with bond development. Instead, use a vacuum with a HEPA filter to clean the concrete substrate/subfloor
• For slabs containing petroleum-based products, the slab should first be thoroughly cleaned with Maxxon Commercial Profile
• Existing tiles must be securely attached and completely bonded
• . Maxxon Commercial Isolate cannot go over latex or water-soluble adhesive, such as a pressure-sensitive adhesive
• For below-grade applications, you must mitigate before installation of Maxxon Commercial Isolate.
• Maxxon Commercial Isolate is not approved for use over creosote
• Wait until the first coat is completely dry before applying a second coat. Wet-on-wet applications must be avoided.
• Only leave mixed Maxxon Commercial Isolate in the pail for 10 minutes without reconstituting settled fillers. Use the mixer blade for 15 seconds to reconstitute any settled fillers back into the mixture
• Do not remix more than once as the material can react in the container and see a temperature rise to 180 °F
• Cracks greater than or equal to 1/8" (3 mm) must be filled before Maxxon Commercial Isolate installation
• The product does not mitigate issues related to hydrostatic pressure