Maxxon Acousti-Top Adhesive 5 Gal Bucket

Maxxon Acousti-Top Adhesive 5 Gal

The High Compression Resistant Solution for Specialty Care Units is the suggested specification for a High-Strength Maxxon Underlayment over a Maxxon Acousti-Top sound control mat.

Features

• Install the Acousti-Top mat into wet or tacky Acousti-Top Adhesive with seams butt jointed
• During application, take care to avoid wrinkles and bubbles forming under the in-mat
• Coverage: Approximately 1250 Sq ft.
• Acrylic copolymer for bonding Acousti-Top Floor Underlayment to a concrete subfloor or other Maxxon-approved subfloor
• Requires no mixing or dilution. It is ready to apply directly from the pail.
• High molecular weight
• High static thickens with the addition of alkali
• Once Acousti-Top strips are placed, back roll with a weighted floor roller to ensure that 100% surface contact is achieved
• Ensure that no air pockets or folds have resulted from back-rolling
• Suitable for use with radiant flooring
• Fast, easy installation
• Install over new or existing concrete, gypsum, or wood subfloors when topped with a gypsum underlayment.
• For glue-down installation, the dry Maxxon Underlayment must be sealed using Maxxon Gypsum Overspray before adhesive application

Installation Method

• The subfloor shall be structurally sound, fully dry, clean, and free of mud, oil, grease, dirt, dust, and other contaminating factors. Do not mix or dilute with water. The adhesive is ready for use directly from the pail. If Acousti-Top is installed over a Maxxon underlayment, the underlayment must be dry and sealed before adhesive application using Maxxon Overspray or Maxxon Acrylic. Roll 1/4″ nap roller, brush, or spray adhesive at a rate of 300 square feet per gallon. Apply the adhesive in 48″ wide strips and place the Acousti-Top into the wet or tacky adhesive and dry roll with a standard resilient floor roller to ensure 100% adhesive coverage below the mat. Minimizing working over the adhesive throughout the installation. Rough hollow core precast plank or rough concrete may require the Maxxon underlayment slurry coat attachment method. Isolation strips are installed around all walls, doorways, toilet collars, and other floor penetrations. Seams shall be butt jointed on thin pours or may be overlapped on pours thicker than 1/2″.
• Maxxon Gyp-Crete family of products Standing the test of time since 1972, Gyp-Crete makes for safer, quieter living and has become a standard in apartments, condominiums, townhomes, hotels, and motels nationwide and abroad