StoneTech Bulletproof Sealer

StoneTech Bulletproof Sealer

Use on natural stone such as marble, granite, limestone, slate, and travertine.

Features

• Maximum penetrating microbond protection
• Heavy-duty protection against most stains
• It makes cleaning stones easier
• Preserves natural look
• Water-based formula
• Interior and exterior

Directions for Use

• Allow new grout installations to cure for a minimum of 72 hours before application
• Make sure the surface is clean and free of waxes and coatings
• Sealer may be applied to damp surfaces 1 hour after standing water is removed
• Surface temperature should be between 50°F and 80°F
• Ensure that the area is well-ventilated during application and until the surface is dry
• Mask any surfaces not intended to be treated
• Apply sealer evenly and liberally using a paint pad, roller, brush or low-pressure sprayer
• Allow sealer to penetrate the surface for 15–30 minutes
• During this time, keep the surface wet with sealer, adding more sealer as needed
• DO NOT ALLOW SEALER TO DRY ON THE SURFACE COMPLETELY
• Remove excess sealer by wiping the surface thoroughly with clean, dry towels
• Should a sealer residue appear, rewet the impacted section of the surface with sealer
• Agitate the surface with a white nylon scrubbing pad to loosen residue and wipe dry with a clean, absorbent towel
• A complete cure is achieved after 24–72 hours
• Foot traffic may begin in 6–8 hours. If needed sooner, cover the floor with red rosin paper to protect it until full cure is achieved
• Clean tools used during application with water

Available Sizes and Coverage

• Pint: up to 112 sq ft
• Quart: up to 225 sq ft
• Gallon: up to 900 sq ft for a single coat application
• Expected Wear: up to 5 years on interior surfaces and up to 3 years on exterior surfaces