StoneTech Honing Powder 800 Grit Extra Fine

Laticrete Stone Tech Honing Powder 800 Grit Extra Fine

Features

• Creates honed finishes
• Sets up the stone for polishing and shining
• Different grits eliminate mild to deep scratches
• Non-acidic
• Coverage (600 Grit, 800 Grit): 750-1,500 sq ft per pound

Where to Use

• Natural stone such as marble, limestone, travertine and terrazzo

Directions for Use

• Read the entire label before using it. Use only as directed
• Always test in a small, inconspicuous area to determine ease of application and desired results
• Allow new grout installations to cure for a minimum of 72 hours prior to application
• Make sure the surface is clean, dry, and free of waxes and coatings
• If the surface is heavily soiled, pre-clean with StoneTech Professional KlenzAll Cleaner if needed
• Mask any surfaces not intended to be treated. If you are using a variety of abrasive grits, ensure that the surface is well-rinsed and a new pad is used for each changeover
• Apply approximately 1/2 cup Honing Powder plus 1 cup clean water to the stone surface
• Refinish using a hand orbital sander or weighted floor machine at 130–140 lbs, 175 rpm, fitted with a natural hair pad. Keep the compound wet while refinishing with plenty of water
• Add Honing Powder as needed
• Refinish the area until the desired level of hone has been achieved
• Rinse well and use a wet vacuum or hot water extraction unit to remove all remaining compound
• Clean equipment with water
• Use successively higher grits of Honing Powder to close the face of the stone and follow with StoneTech Professional Polishing Powder and StoneTech Professional Shining Powder as applicable